Results 1 to 7 of 7

Thread: 4 dots not flashing

  1. #1
    Junior Member
    Join Date
    Dec 2004
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts

    4 dots not flashing

    my friend brought to me a humax 5400 and when i plug in then i have four dots not flashing only one small dot under four big one flashing, then receiver is not responding to buttons or remote control

    is there anyone with same problem and solution?????

    thanks

  2. #2
    V.I.P
    Join Date
    Dec 2004
    Posts
    2,721
    Thanks
    20
    Thanked 22 Times in 9 Posts
    Releoad your channels m8, that's usually what that problem is - just download the channels posted in the stickies.

  3. #3
    Member g ali's Avatar
    Join Date
    Dec 2004
    Posts
    65
    Thanks
    0
    Thanked 0 Times in 0 Posts
    had this problem b4 reloading the channel list through humbox or hnf smart should solve the problem as mentioned by mrdude. good luck

  4. #4
    V.I.P.
    Join Date
    Dec 2004
    Posts
    1,648
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Guys read his post again "4 dots not flashing" not three dots flashing which indicates missing settings

    Maybe it will fix it anyway


    TNT

  5. #5
    V.I.P
    Join Date
    Dec 2005
    Posts
    554
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Quote Originally Posted by padamos View Post
    my friend brought to me a humax 5400 and when i plug in then i have four dots not flashing only one small dot under four big one flashing, then receiver is not responding to buttons or remote control

    is there anyone with same problem and solution?????

    thanks
    Are the four big dots dashes instead? I could understand that, as it would signify that the time is not set. As for why the box doesn't respond to the buttons nor the remote (assuming the batteries are good) then there's possibly a fault with the front interface board. Look inside for loose connectors.

    Did your friend say that the Humax was working when he brought it to you?

  6. #6
    Junior Member
    Join Date
    Dec 2004
    Posts
    5
    Thanks
    0
    Thanked 0 Times in 0 Posts
    my friends thanx for the replies the problem is very simple.......

    after talking with him i found out that he tried to reload loader
    and i guess he load wrong loader

    the solution is z-board operation.

    (--.--) that is what i get only small dot flashing

  7. #7
    modest supermod voith driver's Avatar
    Join Date
    Dec 2004
    Location
    north kent coast
    Posts
    349
    Thanks
    0
    Thanked 0 Times in 0 Posts
    hi padamos,
    thats a much better clue as to your problem thanks, i would suggest you try to load just the original firmware for 5400, without loader, you do this with hdfsmart or hu15, and a nullmodem lead, then load a channel settings file, with hnfsmart, this with luck should get you to a FTA box, then you can check out the sys id ect, and make a better judgement on where to go next
    hope this helps
    voith

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •