your cam may be stuck in initialising loop.
Please try the following
1. put your stb on a fta channel & switch your reciever off @ the mains.
2. remove your cam
3. reprograme your loader card with the last known good file you used.
4. re insert your loader card into your cam then re insert your cam into your reciever.
5. switch your reciever back on at the mains.
6 go into your recievers cas menu if you see dragon or t-rex loader continue to load as normal.
if not your boot loader has gone this can be repaired by vanhoof.
Code:
http://-www.tv-digitaal.eu/
regards compass.
Bookmarks