Largest dish on a Diseqc motor ?

[dostoy]

I have a 1.1 metre Triax dish on a Diseqc motor and I would like a bigger dish.

I think that the largest wall mounted dish is a 1.2 metre and I wondered if it was possible to fit a 1.2 dish on a Diseqc motor.

Does anybody know ?

Thanks.

[echelon]

depends on the motor

there are 2 types of diseqc v1.2 motor , for 1.0 metre and 1.2 metres , either can usually take a 1.1m dish , but the maximum a 1.2 motor can take is the 1.2m obviously

but I dont think an increase of 0.1m will give you anything at all , you would more likely get a better increase with a more sensitive lnb

[dostoy]

I see.

I have a 0.6 gold Universal LNB.

Is there an LNB that would work better with a 1.1 metre triax dish ?

Thanks.

[wellwell]

hi, think you can have larger dish if its ally {cos ally is lighter}

[dude66]

Also keep in mind the high winds that we are getting regularly....Gone through 3 motors in 3 years because of storms...make sure it is well sheltered...
Dude66

[satwyn]

I have a 1.1 metre Triax dish on a Diseqc motor and I would like a bigger dish.

I think that the largest wall mounted dish is a 1.2 metre and I wondered if it was possible to fit a 1.2 dish on a Diseqc motor.

Does anybody know ?

Thanks.

stick with the triax 1.1 they are light and quite good performers you would need to change to polar mount to have anything bigger

[bulmers]

I wouldnt use anything else other then an Invacom 0.3db LNB on my Triax 1.1m.

https://www.goldwafers.co.uk/product...1&cat=5&page=1

I would also recommend sticking with the 1.1m Triax. They are a good performing dish and stand up well to the weather. Ive got mine for about 6 years and It still looks as good as the day it was installed. (I clean it every few months with warm soapy water)

[Xtremezz]

My 1.2 m dish killed the 1.2m capable Disecq in the end... Though coulda been just not good enough an engine. I'd stick with the 1.1 for your current setup.

[dostoy]

Interesting.

Thanks for all your replies.

[keymaster]

Hi
I have the satcontrol motor - that takes up to a 1.4 ally dish.
cheers
Key

[vrlika]

I have 1m gibertini thought the same to upgrade to 1.2m on my darkmotor with metal gears but am a bit concerned on the weight side of a 1.2m gib. ,so you guys reckon that triax 1.1 is probably the best max size to go for for the diseqc motor set up ?
would i gain much if i upgrade to 1.1m triax ? ps. thinking of 23.5e kabel kiosk,11w,showtime,etc,thanx.