On your PC:
Start/Program/Accessories/Communications/Hyper Terminal
Setting the Hyper Terminal
1. Start Hyper Terminal.
2. In the field "Name" write for example Samsung 9500, choose an icon and click OK.
3. In the new opened window, near "Connect using" choose "Direct to COM1, afterwards click OK.
Port Settings
1. Bits per second : 115200
2. Data Bit : 8
3. Parity : NONE
4. Stop Bit : 1
5. Flow Control : Hardware
Click OK
Uploading software using Hyper Terminal
1. Choose TRANSFER
2. Then choose SEND FILE ....
3. BROWSE - select from hard drive the desired version of software (e.g. DSR9500_Eurocam_5-1_EMU_vXX.bin)
4. Choose 1KXmodem for Protocol
Don't press the button "Send", you will do it subsequently.
After you have done the procedure described, connect your computer with Samsung using a RS232 connection cable.
Before you start uploading the new software into Samsung I would advise you to firstly remove all the cams or cards from it (if any are inside).
The things you have to do are :
1. Disconnect your Samsung using the switch on the rear.
2. In the front of Samsung keep pressed the "right arrow" (volume up).
3. Power up your Samsung on the rear switch and keep constantly pressed "right arrow" (volume up).
Keep the "arrow" pressed until the "3-01" appears on the display,
from that moment the computer will show "............................ ... Loading"
4. In that moment, in the Hyper Terminal, click the button "Send" (you have about 15 seconds to perform that operation).
With clicking on "Send" starts the uploading the software into Samsung.
Don't be hasty! Wait for entire process to terminate.
Process is terminated when on the Samsung a clock appears.
That was it.
Bookmarks