So glad i did not waste my money , BISS Auto Server been OFFLINE for a month already
now no further updates for PVU so far ...
Think i will just buy TBS5927 which will do much,much more than any china box ever will
So glad i did not waste my money , BISS Auto Server been OFFLINE for a month already
now no further updates for PVU so far ...
Think i will just buy TBS5927 which will do much,much more than any china box ever will
Auto biss was working well for me on my Viark Droi today.
Not used my Viark Sat HD for a week or so.
Originally Posted by Satcat
The problem I have now is that after the box is rebooted I have to go into softcam manager and manually start oscam, even though I have "enable startup" ticked.
I also takes 3 or 4 presses of start before it does connect, after which it works fine.
Any Ideas?
reported on other forums that there is a problem,some people having to press start up to 10 times before it runs
Freesat update fw for AFNSo glad i did not waste my money , BISS Auto Server been OFFLINE for a month already
now no further updates for PVU so far ...
Think i will just buy TBS5927 which will do much,much more than any china box ever will
https://www.satpimps.co.uk/showthrea...a-firmware-etc
Might be you have two readers with afn in them. Known oscam issue.
I have since found that it does start itself if left alone for a while.
Of a night I put my box into deep standby and have the power timer set for 8am for it to wake up and go to standby, and when I come to switch it on, mid morning, all is well.
Only took one minute to auto update this evening after not using my box all week.
The key update EMMs cycle through the UAs in numerical order. The full cycle takes about 50 minutes. There is a few minutes pause and then the regime starts again. How long it takes for you to get a hit depends upon the number and values of the UAs you have in your softcam.key file and also just when you join the AU EMM cycle.
If you are lucky, one of your UAs will be just slightly higher than the UA value currently been sent and the AU will happen quickly.
If you are unlucky and all of your UAs have passed then you will have to wait for the cycle to start again and the AU could take possibly 30 minutes.
If you can organise your softcam.key file to have a good number of well spaced UAs you can minimise the wait time.
The UA range is from about 001xxxxx to about 006xxxxx. I believe up to about 15 UAs can be employed.
Posting Permissions
Reply With Quote
Bookmarks