Results 1 to 3 of 3

Thread: Ultimo behaviour with usb stick plugged in

  1. #1
    Member casper2's Avatar
    Join Date
    Dec 2011
    Posts
    56
    Thanks
    0
    Thanked 5 Times in 4 Posts

    Ultimo behaviour with usb stick plugged in

    I am running a VU+ Ultimo currently at v2.0.7 but the problem i have occurs at all BH versions.
    To run Universes you have to set up a memory stick to store the different universes. I have this setup and permanently plugged in to the top USB socket on the back of the receiver.
    I have tried 3 or 4 different USB sticks but my Ultimo will not perform a full system reset with the memory stick installed. If i do a reset the restart just sits with a blank screen and does not progress. I have to turn off the receiver turn on, wait about 10 seconds and then plug the USB stick in again so that the universes data is picked up.

    In fact the same behavior occurred when the USB stick was being setup, formatted & mounted. During the setup the system requests that the receiver be restarted a number of times. On my receiver if i go ahead and say yes to restart it hangs and will no reboot until i turn of power uplug the USB stick power up and plug in the USB stick after about 10 seconds. It is a real pain if i get a green screen crash and have to go through this procedure each time to get up and running again.

    Does this behavior occur on all VU+ receivers or just the ULTIMO, or is my ULTiMO behaving abnormally? It has behaved like this from new.

  2. #2
    V.I.P DCG's Avatar
    Join Date
    Dec 2004
    Posts
    1,627
    Thanks
    2,405
    Thanked 1,255 Times in 666 Posts
    I don't have that problem on my uno

  3. #3
    Member casper2's Avatar
    Join Date
    Dec 2011
    Posts
    56
    Thanks
    0
    Thanked 5 Times in 4 Posts
    Anyone with an ULTIMO have this problem, or is my receiver faulty?
    Once running as explained above it behaves perfectly.

Similar Threads

  1. CAM ToH3.4 plugged HoT11.3a_b.bilge Restore / 26.10.2010
    By Glenn_911 in forum Tools & Editors
    Replies: 0
    Last Post: 27-10-2010, 09:27 AM
  2. CAM ToH3.4 plugged HoT11.4b.hdf / 05.03.2010
    By Glenn_911 in forum ToH Firmware
    Replies: 0
    Last Post: 06-03-2010, 08:39 AM
  3. hot plugged 9(1)8
    By maxhum in forum Humax
    Replies: 9
    Last Post: 21-12-2007, 12:16 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •