Dear Alan Smith,
Please try to do like this.
1. Null-modem cable (Connectors: DB9 Female x DB9 Female)
Contacts:
Connector 1 2 ……………. 3 Connector 2
3 ……………. 2
4 ……………. 6
5 ……………. 5
6 ……………. 4
7 ……………. 8
8 ……………. 7
The cable you can buy in usual computer shop. Check cable contacts by tester.
2. COM port configuration for PC and Channel Editor 3.11 (or 3.1):
Bits per second: 115000
Data bits: 8
Parity: None
Stop bits: 1
Flow control: Hardware (or None)
3. All devices (for example, mouse) must be switch off from RS-232 (PC port) through control panel and restart Windows.
4. Please change .hdp on .dlp for your software (for example, SW 025701.dlp).
5. Save your settings if it’s necessary, then remove cards, CAMs and receiver plug from electrical socket and set receiver selector on the rear panel in position off.
6. Connect PC and receiver by null-modem cable then insert two plugs in sockets.
7. Switch on PC (Windows starts) – Vantage stays switch off
8. Please start Channel Editor 3.11(or 3.1) and push the button
”RS-232” for port control checking.
9 Push button “UP” to select software then press button “Open”
10 Immediately switch the rear panel selector in position “ON”
11. Please watch to receiver display next information:
- Downloading- DL Main- 0 to 100% - about 10...11 min;
- Flashing – 0 to 100% - about 4 min.;
- Loading 1;
- Booting;
- Welcome;
- Name of any Channel.
Remove receiver plug from socket (don’t touch rear selector)
Upload is finished and my best wishes for you.
Bookmarks