Originally Posted by
pr2
Hi,
I have tried the wifi with firmware 0.9.2371, I have a G WiFi Network protected via WPA2. I can connect to my D-Link access point and receive IP via DHCP (range 10.0.0.x subnet 255.255.255.0), I also test by setting up a fixed IP in the Azbox on the WiFi connection and it works fine.
The only thing I point out is that if you are wired and enable the WiFi both remains active at the same time (until the 1st reboot).
But when you switch from wifi to wired then the wifi is immediately stopped without the need of a reboot. (I already escalate this remark.)
Once again, check that your Access Point is able to handle B/G and enable it. Some new N router are configured by default to support only N.
Moreover if you use a WiFi AP with a special boost fonction disable it since it is then using a non-standard method to boost the signal so only equipment able to handle this will successfully connect.
Don't you setup a MAC address filtering in your router?
If you use WPA, the passphrase is case sensitive.
Pr2
Bookmarks