Recovery instructions for HD6000

Recover STB using RS232

Instructions :

Unpack the Hyperterminal zip file below using 7zip or Winzip or Bandizip after downloading it

Unpack the repair firmware zip file below using 7zip or Winzip or Bandizip after downloading it

Steps:-

01. Install HyperTerminal

Code:

---


https://skydrive.live.com/?cid=b98f3d302358df4a&resid=B98F3D302358DF4A!222&id=B98F3D302358DF4A!222

---

Code:

---

(if not exists in your PC's windows: Start****All Programs****Accessories****Communications****HyperTerminal)

---

02. Turn off STB
03. Connect RS232 Cable to STB and PC and execute HyperTerminal (use a fully wired null modem cable)
04. Make new connection - make name
05. Select Com port
06. Set Speed and other (115200 – 8Bit – No parity – 1 StopBit – No HW control)
07. Press space on HyperTerminal every 0.5 seconds (half a second) from the time when turn on STB,
08. When HyperTerminal shows the below picture on PC, then stop pressing space.
09. It shows to ask to select one of menu from 3 menus.
10. Select “2. Upgrade Application with Xmodem”
11. Select menu->Transfer->Send File in HyperTerminal
12. Set protocol Xmodem and select (not type)

Code:

---

navi_s_326su.flash.gz.gro.stp

---

and press Send button

read these threads for hints and links about using the correct tools and leads and windows

https://www.satpimps.co.uk/showthrea...Com-port-setup

https://www.satpimps.co.uk/showthrea...king-up-a-lot-

https://www.satpimps.co.uk/showthrea...-Recovery-film

https://www.satpimps.co.uk/showthrea...em-with-6000HD

https://www.satpimps.co.uk/showthrea...ery-check-this

https://www.satpimps.co.uk/showthrea...for-hard-reset