phoenix apollo ci+mc

[satpaul]

will add channel list and PO Edit to load it tomorrow night when I get it off my laptop:respect-055:

Have uploaded it

[drahcirk]

THANK U VERY MUCH SATpaul , respect,.

[drahcirk]

did the upgrade to open box 820, put in the number to change to yes, but, it wouldnt let me put in the sw to start,so therefore im clearing nothing, some input would b appreciated,.

[satpaul]

Load the converter file then load the latest software then go to menu 1117 turn patch on load my channel list with PO Edit and key file simple as that:applause-003:

[drahcirk]

thanks satpaul, dont know how to load latest s/ware, or where to get it sorry for being a pain,.

[satpaul]

latest software at top of page everything you need all in the rapidshare downloads:king-042:

[electral]

will add channel list and PO Edit to load it tomorrow night when I get it off my laptop:respect-055:

Have uploaded it

Many Thanks.:respect-054:
cheers..

[drahcirk]

i give up, keeps saying wrong file, will go back to apollo soft,.

[satpaul]

which Phoenix do you have

[drahcirk]

ap0llo ci+mc, however just realised not working with old either, think when my comp crashed 2 months ago, lost the loader ,i d/loaded,.

[Andrew007]

i give up, keeps saying wrong file, will go back to apollo soft,.

drahcirk

To Load the conversion S/W use the Phoenix Apollo Loader called "All_Updater(1.00)"
The S/W is the Conversion S/W named "wsw" File.
Make sure you have the right S/W Version for your Box..!
Before you Open the AllUpdater V1.0..
put your STB in OFF at the Mains use the switch on the back.!
That's important otherwise it will NOT connect properly..!

Now Insert your NullModem Cable..
Open the All Updater(1.00) and Set up your COMM Port..! now Load the S/W File press Update and NOW Switch the Box ON using the Back Mains Switch..!
AND WAIT until it shows an "" 8 "" in the Display..
First you see three Green Lines being moving across the Screen then a " n " then a " 0 " wait patiently until this finishes and you see the "" 8 "..IMPORTANT..!!
Takes about 5 to 6 mins..

Now you can Scan your Sats after this Operation if you wish..they will remain in place after the Openbox S/W is Loaded.

Loading the Openbox S/W use the Updater for Openbox S/W " OpenBoxUpdater_v2_RC4 "
Same procedure as above..
WAIT until you see the "" 8 "" Displayed on Sceeen.!!

Now go to Menu > Press 1117 on your Remote and Activate the EMU..

Now using the "All keys + tps - Pobedit - 0.922 " Load the latest Softcam and you are Up and running..
You only need to do the Key Reset.
ALL Finished..:respect-010::respect-057:

Enjoy.
Cheers
Andrew

[drahcirk]

thanks andrew will try that, i appreciate your reply,.:respect-047::respect-047:

[Andrew007]

thanks andrew will try that, i appreciate your reply,.:respect-047::respect-047:

drahcirk
AS you have the CI+MC then look in the Software Section I have Uploaded the most Recent S/W Version and the Latest Softcam for you..OK
To Load the Softcam the BOX can remain ON..
NO problem with this.

enjoy.
Cheers
Andrew

[drahcirk]

d/loaded and progged to open box no probs, but this is where my prob isi havent got what u call v2rc4 ,cannot see or find this n e where,.