Quote Originally Posted by tobyman6 View Post
This is making me think the geometry of the Supreme motor is not correct!
Not relevant to your problem but I've only set up one Dark Motor and no matter how we tried to reset/send to zero it always went back so the indicator and seam were about 2E. Following that line through the dish and boom it was obvious to see that it was not straight. I got it tracking OK in the end but it took longer than normal and I definitely don't want to see another one, nasty bit of junk!

One of my dishes is on a 2100A and when I put the dish on it I took a photo from underneath that showed both the motor and dish, dropped it into Paintshop and drew a line from the LNB to the back of the motor, you can very quickly see how accurate the alignment is. As Echelon says eliminating the non variables before you start the L/R U/D stuff really is worth the extra few minutes it takes to do.