Hot 8.07

**DAYDAY** · 01-08-2007, 04:54 PM

Thanks for the tip on turning the Hummy on and off at the back........

Ended up with sod all today so checked the boards to see if it had all gone pear shaped

Just read your post and went to France 4 and powered off and back on and everything is superb again

Big Thanks

**marco1** · 02-08-2007, 07:29 AM

Originally Posted by Marco

if you dont sse any keys in ram editor. try putting catone on again
then put key bin in you hummy.and you will see your keys in the editor
then try for tps au again

Thank you very much Marco for your reply. I have made all you said above but unfortunately i'm not able to put my hummy working. I have put catone v3.2, after the last humax key.bin and the problem is always the same - the Ram Editor only with "zeros". Thanks anyway mate, all the best for you.

Marco1

**Mansoor** · 02-08-2007, 07:47 AM

Removed an IRDEO cam from the receiver which I use for Jazzera channels and got TPS to AU, changed the settings from irdeto only to I/V/C/N and everything works okay now
thank you guys

**Marco** · 02-08-2007, 03:07 PM

marco1 try puting firmware on first then HOT 8.7
see if this makes a difference

**fantom** · 02-08-2007, 07:46 PM

Thank PH and team ...

**fabled** · 02-08-2007, 09:26 PM

As most of you have this working correctly, this may seem inconsequential, but you never know, someone may need this information.

At first I could not get the AU to work, blank screens on all TP$ channels. Tried all I could think of, including complete power downs. The next step was to remove the CAM in one of my CI slots after first powering down (Main Switch).

Rebooting into France 4, 10 seconds later, success. Changed to the free MultíVi$íon channel, pushed the CAM back in (not good imo), which initialises, and I'm good to go.

Thanks therefore to all relevent members of the sat world for bringing us this release.

Fabled.

Forget the above there's a new HoT out