-
SBCL and vPlug on a Relook
Hi, is there any one running SBCL and vPlug on a Relook?
I done some tests with HL image and got some problems.
-
-
V.I.P
You cant use dreambox plugins on relook.
-
-
@samot4
sorry to contradict you, i'm quite sure (many friend told me)
with sbcl and vplug on pc
connected to relook with good cccam.cfg line seem that's possible
-
-
vplug is a pc program , since relook uses same emus as dreambox
there is no difference in this matter .
you just need to have xp (older os's will not work) installed on the pc
and you need to run an emu with newcamd protocol support on your stb .
-
-
newcamd protocol
Thank you for your answers.
I got it to work as far as this:
22:34:52: TCP Login accepted
22:34:52: TCP Ncd TX: 000000010000000000000000E10000
22:34:52: TCP Ncd RX: 001800020000000000000000E30000734 8DA
22:34:52: TCP Sending Card Info
22:34:52: TCP Ncd TX: 000000020000000000000000E40024000 50000
This is only result I get. My plugin run evocamd + newcs at the same time. Newcs is that newcamd?
Best regards
Last edited by speja1; 09-01-2007 at 09:34 AM.
-
-
V.I.P
Oh its a pcprog got confused by the first post where he states he is running it on relook.
No newcamd and newcs is not the same.
-
-
Successful report?
Many thanks again.
I would be grateful for any Successful report with SBCL and Relook (sat receiver ).
I tried Highland and Fantacy image with no function or panic.
-
-
Member
Got it working fine using both Highland and new SF Enigma image (Yes Dreambox software does work on relook).
Make sure you forward Port 6001 in your router as well as the CCamd config line.
Havent tried it with other Emus like Mgcamd and Evocamd but understand these work fine too.
-
-
Thanks kxxx.
Thanks kxxx.
It’s lovely to know Relook perform. I will try with Highland again. Thanks M8
-
-
T*S.bin and Relook
Last edited by speja1; 11-01-2007 at 10:24 PM.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks