connecting hyperterminal

[larnerj]

hi there my spider 6000hd is in a on and off loop im trying to use hyperterminal but can not get it to connect any help please

[Mickha]

Have you read this thread?
https://www.satpimps.co.uk/showthrea...for-hard-reset

[larnerj]

thanks mate

[KARABANGA]

Hi Hyperterminal works very well with Windows XP...i have used it many times to reflash broken Spider6000 boxes.. if further help is required i can post further info.

Regards

[larnerj]

thanks mate im using windows 10 and I just cant get it to connect at the very beginning im sure if I could get it to connect it would work fine any ideas

[KARABANGA]

Hi Not sure about windows 10 but have you checked the following:

1) Are the cables connected properly between laptop and Spiderbox.
2) Does Windows 10 have COM ports
3) In Hyperterminal have you set the correct paramaters
4) before you start the Hyperterminal session make sure box is powered off
5) When you press the spacebar do you get any messages

I know Hyperterminal works fine on XP and is easy to setup. Can you send details of the paramaters you are using so i can check against mine. Regards

[larnerj]

I will check all what you sent later I have to go out today .but thanks for your help mate thank you so much very very helpful im sure ill get it right in the end thanks to you

[Weston Calling]

It may also be worth reading this thread - https://www.satpimps.co.uk/showthread.php?169218-On-and-Standby-Loop/page3

[larnerj]

thanks will try