Your Longitude reading is 001312 West, altering this will change how your motor calculates where to move/stop the dish. Shouldn't this be 001.312 West? So that your location is Latitude 53.62 degrees and Longitude -1.312 degrees?
Setting up a dish, using USALS, you set everything to 0, motor and LNB, so that you get the LNB skew, rotation, correct, when the dish motor moves the dish.
You then enter your Latitude, and Longitude, into your receiver, select a satellite, for your receiver to move the motor to, usually one close to your Longitude, which is your true south, and 0.8W seems closest.
Once done you physically move the dish/motor, on your pole, to get the strongest signal. from 0.8W, then fine tune your dish elevation, to get the best signal quality.
You then tighten everything up and use your receiver to send your dish to the furthest East satellite, you want, and furthest West satellite, making a not of the signal quality readings.
You then move back to 0.8W, make minor adjustments, to the motor/dish brackets, if necessary, and check East/West again.
You then keep doing this until you're satisfied that your dish is tracking the satellite arc.
Bookmarks