Just bought a 9000HD from a well known ******* site- supposedly described as "fully working" however on trying to access the installation menu for the satellite search/manual setup/disecq switch/factory reset this requires access via a 4 digit pin I can only input 3 digits the fourth does not register in the pin number box- I am assuming the full pin is 0000.
Have I been sold a faulty box?? I am assuming I have. :(
Last edited by nibber; 01-09-2016 at 04:21 PM.
can you access the menu to load new software you could try installing fresh software if possibleOriginally Posted by nibber
Hi,
Thanks- I think I can access the other menus,but I have not tried that yet -I just wanted to do a factory reset but cannot access the install menu.
yes understood but if you load fresh software it may give you access to the menu you need and clear the pin issue also i'm not sure if you can set a 3 digit pin on the receiver instead of the factory 0000 but probably not you could ask the seller for the pin
Last edited by satwyn; 01-09-2016 at 05:55 PM.
Have already asked the seller he is telling me it is 0000!
The receiver refuses to accept the 4th 0 of the pin
will try to load new software
I have made a backup of the old settings on a usb stick
Sorted,
Just installed the latest Vasicks patch from the forum which has cleared the pin issue- I can now access the installation menu, cheers
yes some very dishonest people about the receiver is not fit for purpose if you bought it as fully working you could send it back and buy a new 6000hd
Posting Permissions
Reply With Quote
Bookmarks