Using channel editor 2.1.1

[chopper1]

a lot of my channels have needed updating so i created a new database channel list Using channel editor 2.1.1
got all sorted but for some reason the motorised dish will not move, when i go to saellire settings-motor says none not diseq1.2 which i use
Will i have to remember each satellite position number and store for each satellite or is there an easier way round this?

[Aldo]

" Will i have to remember each satellite position number and store for each satellite or is there an easier way round this? "

Yes you will, and No there is not, you should read this in the Setup Procedure:

Satellite Setup

Go to Menu / Sat Settings, scroll down the left hand list and click OK to select all the Sats you want to scan, this will give them a tick.
Right arrow across, scroll down to Motor, right arrow to select ‘Diseq/Usals’, OK, Scroll down to Mode, select Drive to Satellite, scroll down to Set Location, OK, Scroll down Set Long then Lat then save, scroll to Go ‘Save Data and run’ thats it.

[finestrat]

I use a Vbox not Diseq motor, when I save, I choose user database which for me saves all the sat positions as well as the channels. Might be different for diseq motor.