morning all' for some unknown reason my spiderbox has stuck itself in a constant loop when i switched the unit on this morning was fine last night' tried unpluging everything from the unit and just power running to it and its just the same just get - - - - then on then standby cycle.
Hi
First try disconnecting the LNB cable from Spiderbox and retry, if same and you are not able to repatch with latest F/W you will need to use the recovery method.
Recovery Tool > https://www.satpimps.co.uk/showthrea...ons-for-HD6000
Recovery Video > https://www.satpimps.co.uk/showthrea...-Recovery-film
jb
yes mate still does the same without lnb cable, without any cable plugged in anyway just power.many thanksOriginally Posted by jbvid
try the recovery tool and factory firmware etc (using a null modem cable from xp pc) , then do a factory reset from the menu
then load the aug 2013 firmware if successful and factory reset it again
then load july 2014 firmware and factory reset it AGAIN
then load channel list etc and test it
EDIT
TYPO corrected, thanks to cannydo spotting it
Echelon should that not be July 2014 firmware??
had to send the unit back guys' must of been a manufacturing fault' lets hope replacement will be fine fingers crossed.wish i just kept my f5s now :(
I think I'll ask you that question in about a fortnight m8 hehe you'll find the Spiderbox much superior to an F5. You've just been unlucky enough to have a faulty box once you have a fully working one you'll not look back.
which is the best way to patch the box when the replacement arrives' with the last unit i just done a factory reset first' then installed the latest patch then done a factory reset once more' is this fine or do i need to install a earlier patch first before latest.many thanks
As instructed in post for of this thread by echelon m8 you need the old patch first.
Post 4
what date should i be looking for' before flashing over new patch.cheers
As the post m8 Aug 2013 then factory reset check info on box make sure it reads Aug patch. Then the latest patch again reset and if you have a channel list install now there are channel list for spider in this forum.
ok many thanks cannydo cheers bud
You can patch it via usb as well easier in fact Software Update here's the link to the channel lists.
https://www.satpimps.co.uk/forumdisp...-Channel-Lists
thanks matey' this is the first august 2013 patch i could see 06/08/2013
You can patch it via usb as well easier in fact Software Update here's the link to the channel lists.
https://www.satpimps.co.uk/forumdisp...-Channel-Lists
its 30/08/2013 , factory reset and check the date in the menu, then its the LATEST patch after that, which is currently 24/07/2014 , followed by another factory reset and again check the date in the menu once more
it should go without saying that if a new patch comes out then its that one you install and not july 2014
thank you very much guys' just need to set my zone 2 dish at a sat now still not sure wot to point it at though wots best with iks thnx
13e or 19e IK does not open 28.2e. If you check the channel lists you'll will see what suits your tatse.
i see mate' got 28.2e sorted:respect-048: just set up a little zone1 for that sat with a 2 way disecq switch so i can run the zone 2 now and have a little play about with the euro side' should get 13e on it shouldnt i its 80cm x 60cm
Last edited by deano2010; 16-10-2014 at 05:17 PM. Reason: dish size
They are two very strong sats m8 you could probably pick anyone of them up with a saucer hehe.
Posting Permissions
Reply With Quote
Bookmarks