Results 1 to 6 of 6

Thread: New problem with the Elite

  1. #1
    V.I.P Dig Deep's Avatar
    Join Date
    Nov 2006
    Posts
    801
    Thanks
    731
    Thanked 290 Times in 142 Posts

    New problem with the Elite

    Had some problem with ccc, the box did not work so I decided to upgrade (RSI)

    After the upgrade was done it stopped at VFD ready and nothing more.

    However - it was working fine using DCC, got in all all was showing.

    Tested the simple way to go to safety using AZup and it sarted to reboot into safe mode but never did a good reboot, stopped at VFD again.

    Dunno why this happen and how to get it back into real life any ideas are welcomed !

  2. #2
    V.I.P zeini's Avatar
    Join Date
    Dec 2008
    Posts
    455
    Thanks
    5
    Thanked 91 Times in 52 Posts
    Disconnect all HDD and USB-devices and try it again.

    If this doe also not work, perhaps your imagefile is defect.

  3. #3
    V.I.P Dig Deep's Avatar
    Join Date
    Nov 2006
    Posts
    801
    Thanks
    731
    Thanked 290 Times in 142 Posts
    Yes I Think it is defect for sure. Problem is How to re-install or even install something else.
    Canīt find a way ?

  4. #4
    V.I.P
    Join Date
    Nov 2008
    Posts
    719
    Thanks
    1
    Thanked 42 Times in 28 Posts
    Reboot - press volume up

    Be shure receiver is connected through LAN cable not wirelles and DHCP server is enabled on router/modem

    Box wil start in resque mode, now install requered image with Azup 2.2.7 ( windows 7/8 give rights to Azup in windows firewall )

  5. #5
    V.I.P Dig Deep's Avatar
    Join Date
    Nov 2006
    Posts
    801
    Thanks
    731
    Thanked 290 Times in 142 Posts
    It wonīt start in resque mode and if I start Azup it will (of course) try to restart the box in resque but after the reboot
    it goes back into just waiting for the image to load. It is a sad loop.

  6. #6
    V.I.P zeini's Avatar
    Join Date
    Dec 2008
    Posts
    455
    Thanks
    5
    Thanked 91 Times in 52 Posts
    Press Vol+ button during start of azbox. Than you see IP-adress in VFD you can stop pressing Vol+ and flash your box. And very important - flash only with Azup 2.2.7.

Similar Threads

  1. Replies: 1
    Last Post: 23-11-2011, 11:57 PM
  2. Dream-Elite-2.1 (INVALID IMAGE (OR OLD VERSION) problem
    By dragon25slayer in forum Dreambox DM800HD
    Replies: 7
    Last Post: 07-11-2011, 05:20 PM
  3. AZbox Elite Network Problem
    By sharps1 in forum AZBox HD Newbie Questions
    Replies: 1
    Last Post: 01-09-2010, 08:34 PM
  4. AZBox Elite or Premium problem
    By stavross in forum AZBox HD Newbie Questions
    Replies: 10
    Last Post: 30-07-2009, 08:12 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •