Guys,
I am running the latest BH image for my Vu+Solo2 I have noticed where it used to say the ECM time its now showing ECM time: nan what is this and is there a way for it to show the ECM time again?
Thanks in advance Steve..
Guys,
I am running the latest BH image for my Vu+Solo2 I have noticed where it used to say the ECM time its now showing ECM time: nan what is this and is there a way for it to show the ECM time again?
Thanks in advance Steve..
The problem has been around for about 3 or more years, you need to use CCcam 2.2.1 or 2.3.0 or you the search facility on the board to find a patch.
The patch works but is not the best solution.
Happened to me once after an upgrade,......depends on which cam you have installed. The one I have installed at the moment gives the time,...CCcam 2.3.0.
Thanks for speedy replies guys...
Using the attached /lib file cured the problem on my Vu+Duo.
Unzip and FTP to
/lib
and chmod 755
It may well work for you. Back up the original file (if there is one) just in case.
the above file is the only solution and it works on all vu+ boxes and is stable
Make a backup of the original file in lib folder and replace then with above file. Restart enigma2
this still works, just tested on 2.1.3
Last edited by A; 28-12-2015 at 08:47 PM.
Bookmarks