It is not wasting anyones time. Any info will help, even if it is not this time.
It is not wasting anyones time. Any info will help, even if it is not this time.
https://www.satpimps.co.uk/showthrea...hlight=dreamup
Try the search button
tested on 500hd and 800hd
1. switch the box off.
2. Plugin LAN cable AND USB connect to PC.
3. Start dreamup on PC.
4. Tick the 'use network' box in dreamup
5. Set your PC ip address in top left (where it says "local IP(PC)")
6. Set an IP for your dreambox in "Remote IP(box)".
7. Select the COM port which is your newly installed UART bridge COM port (I guess it will be COM15.
8. Click "Connect"
9. It should tell you to switch the DM500-800HD on.
10. Switch on the DM500-800HD and it should download the "flash loader"
11. When it finishes, click on "Flash", select the image you want to download.
12. It should now download the image to the dreambox and start flashing it. Wait for it to finish. Do not switch the dreambox off while it is doing it. It takes a couple of minutes.
13. Switch the box off and then on. It should now boot the new image.
Connect both the LAN and the USB of the dreambox to the PC = 2 cables: 1 x ethernet and 1 x minUSB to USB.
If you plug the dreambox directly to the PC without a router or switch you need a crossover ethernet cable. When using a router or switch you need a 'normal' ethernet cable.
according to the manual at DMM you can flash the DM500-800HD without connecting the LAN (ethernet) and just using the USB , but THIS DOES NOT WORK - flashing fails every time. SO you HAVE to connect both LAN and USB between PC and dreambox and follow the instructions exactly.
Hate to be a party pooper but when my DM800 Clone died last year with the same error I tried everything to fix it to no avail and ended up it scrapping it. Never did get to the bottom of the problem but suspect it may either have been something to do with my running Ferrari images on a SIM2 box or it overheating. :(
no ca found in clone box800. after flashing orginal image.
After using optiflAsher, I get dm800 detected . Wrong boot response.
Any one knows how fix it?
Depends on what sim You got and what image You use !
Buy a VU+ Solo2Originally Posted by frank087234
sim 2.01 . blackhole ssl82
does this help?
I posted some files for pre BL82 (anything lower should work) in this thread which also has some other suggestions and file packs which you could try your luck with (if not tried already).
The patch file is not a full image but is intended to restore the unit into a state where you will be able to boot into recovery and flash from web I/F as usual.
Fingers crossed.
Use the patched DreamUp and upgrade to sll 84
Posting Permissions
Reply With Quote
Bookmarks