Going from Spaze 2.0 to Spaze 2.1 tricks?

[atlas776]

I have gone from ofw to Spaze 2.0 and after some troubleshooting I finally got everything working (ccam was the most time consuming part).

Now I would like to go from Spaze 2.0 to Spaze 2.1.

Does it imply to reinstall all plug-ins, channel lists and configure all from scratch?

Or are there any special tricks to minimize the troubles and time?

[leesmith129]

Hey Atlas

For me i installed spaze 2.1 over 2.0 and reinstalled everything it only takes 2 minute to install Cccam and FTP ur lines over, there may be another way but thats how i did it :-)

Lee

[ManikM]

yer its just a matter of installing cccam (built into image) and then ftp over your sealion

[atlas776]

Thanks guys!

How about the sat channels?

Can I reuse some channel info file in the 2.0 file structure?

[ManikM]

just use catseyes channel list found in VU+ section \ channel lists

[slacker17]

I always back up my channel list through Setup>Software Management>Backup system settings.

[atlas776]

Now I have it up and running! No major problem was seen during the installation.

There is one thing I would like to understand better though:

When navigating to install the CCcam, there are three different directories,

1. Configs
2. Emus
3. Scripts

I would like to configure my box as a client only.

I started under the "Emus" directory and installed the spz_CCcam_2.3.0.mipsel
,then I went to "configs" folder and installed the spz_config_v1_mipsel

finally I went to the "scripts" and installed the scr-cccam2.2.1-mbox4-23r3_v1_mipsel

I have a feeling that one or two of those steps were not necessary (when going to activate the CCcam, I got a choice to start CCcam2.2.1 or 2.3.0 which makes me suspect I actually installed two different version of CCcam by mistake. I only wanted the 2.3.0 version).

I would appreciate if someone could explain what each mipsel is good for.

[sammyjay]

Atlass776, please can you give me exact steps you used when upgrading as i want to upgrade from 2.0
Thanks in advance

Now I have it up and running! No major problem was seen during the installation.

There is one thing I would like to understand better though:

When navigating to install the CCcam, there are three different directories,

1. Configs
2. Emus
3. Scripts

I would like to configure my box as a client only.

I started under the "Emus" directory and installed the spz_CCcam_2.3.0.mipsel
,then I went to "configs" folder and installed the spz_config_v1_mipsel

finally I went to the "scripts" and installed the scr-cccam2.2.1-mbox4-23r3_v1_mipsel

I have a feeling that one or two of those steps were not necessary (when going to activate the CCcam, I got a choice to start CCcam2.2.1 or 2.3.0 which makes me suspect I actually installed two different version of CCcam by mistake. I only wanted the 2.3.0 version).

I would appreciate if someone could explain what each mipsel is good for.