I tryed to road E2 but that was to much work to get it going..so now when i want to go back to the regular firmwhere it wont take the firmwhere..im using a usb-stick
Regards
Drago
I tryed to road E2 but that was to much work to get it going..so now when i want to go back to the regular firmwhere it wont take the firmwhere..im using a usb-stick
Regards
Drago
cmon guys..nobody who have a solution..here is what i did..load enigma 2 with azup and found it not that god...so to go back i try to load an image fw5020...but it always says "not right fw" at the end....what the heck is this?
I put in a usb stick and turn the box off then turn it on again ... with azup i load the new imige but it alway stop at the end .
Any solutions are very appriciated
Take Azup 1.1, not Azup 1.2 go to normal firmware.
Thanks Zeini...that did the thing...with azup 1.1 and remember it must be official fw, otherwise it wont work.....so we stick with old fw until the E2 iz compited
Regards
Bookmarks