Just turned on spiderbox and get f100 error no picture nothing any clues??
Just turned on spiderbox and get f100 error no picture nothing any clues??
f100 shows when it boots on the spider front panel and if you have a channel list it will then go to the last channel you viewed after 0000 shows up
This is the first time i have turned the box on. Should a picture appear? through scart or hdmi. I have nothing.
think you need to have a read mate.
Any pointers manual doesnt seem to help
I DONT HAVE 1 just yet but wooo ,, island boy is only asking!!!!!!!!
please be nice to him common,
Last edited by keith mawer; 01-10-2010 at 07:50 PM.
Had the same problem with mine earlier today.
Try turning it off via the switch on the back, leave it a couple of minutes, and then turn the switch back on. This worked for me.
thanks for your reply no joy. no picture from any av out (scart,hdmi), display stuck on f100 no response from remote or buttons on front of the receiver
NoThis is the first time i have turned the box on. Should a picture appear?
You need a channel listing installed in the box or have setup your sats and done a scan on each sat' and of course set your box up correctly incl' installing the Free Gift and turning on 'Network' - best catch up on some reading me thinks
Last edited by john.dat; 01-10-2010 at 08:46 PM.
As stated to you on another forum m8 talk to supplier if it was straight out of box.Because it should boot up.
Told you already...get your null modem (if you have one) connect it to your serial port of your pc (9 pins socket) and to the box and run the force boot software to reset the box, the loader is somehow corrupted and the box is stuck on f100.
If that doesn't work (please try 6 or 9 times first), contact the seller.
My box is stuck on f100 this morning. I have downloaded the force boot software and followed the instructions below.
1. Switch off STB
2. Run downloadin.exe on PC
3. Select COM port and Press connect button
4. Press "Choose file" and select the attached HD9000_RS232_0629.bin
5. Switch on STB
6. You will see the progress status on PC
7. STB will auto-reboot after finishing the downloading.
The com port is showing connected, I have chosen the HD9000_RS232_0629.bin file and switched on the box at the back but nothing appears to be happening. The progress is still showing 0% after 30 minutes.
Because I have no serial port on this laptop I am using a usb/serial converter. Could this be the problem?
Box returned as was faulty. new one works fine thanks everyone for your help
Looks like mine is faulty also.
Tried loading the force boot software on a friends pc using a direct to serial connection this time and it still stays at 0% progress.
Thanks for your reply.
I can only find the one force boot recovery s/w for the 9000hd
https://www.satpimps.co.uk/showpost....83&postcount=1
Can someone point me to the other one please, and I'll try it.
Thanks for your help.
Have now tried both downloads with the same result. The box is still stuck on f100 and will not boot.
I will contact the seller on Monday to arrange a replacement.
Bookmarks