Results 1 to 10 of 10

Thread: DM 8000 webinterface

  1. #1
    V.I.P
    Join Date
    Dec 2004
    Location
    SW England
    Posts
    939
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Icon11 DM 8000 webinterface

    Do I have to install anything on my 8000 in order that I can access webinterface? webcontrol works fine but when putting my IP address into browser page cannot be found. Many thanks - Brain

  2. #2
    V.I.P Giga's Avatar
    Join Date
    Feb 2009
    Posts
    4,161
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Not your ip address: ip address of your DM 8000. Are computer and DM 8000 in the same IP home address network range and same subnet mask as your router?
    • 10.0.0.0 - 10.255.255.255
    • 172.16.0.0 - 172.31.255.255
    • 192.168.0.0 - 192.168.255.255

  3. #3
    V.I.P
    Join Date
    Dec 2004
    Location
    SW England
    Posts
    939
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Dm 8000

    Hi Giga
    Thanks for the response - I have been in dialogue with oldfart all w/end only to find that there was a break in my network lead. No - I didnt put my address in - I put in the DM IP on the oled screen but when putting this address into the pc it just says page cant be found. I have followed all the instructions to the letter about 200 times but still cant get the webinterface. Is there anything I need to load onto the DM or should I unistall and reload secondstage in case of a fault? All the rest is working perfectly - just a real sense of frustration that I cant trigger this final one point!!Box downloads,is online,all running well but this final step eludes me and I now Ive solved the lead prob I cannot see what else I can do!! I have even tried both a PC and a mac and all on are the same home network/router. !92 168 1 1 is router subnet is 255.255.255.0 and other Ip addresses as well as the DMs communicate.Many thanks - Brain
    Last edited by brain; 27-09-2010 at 10:49 AM.

  4. #4
    V.I.P Giga's Avatar
    Join Date
    Feb 2009
    Posts
    4,161
    Thanks
    0
    Thanked 0 Times in 0 Posts
    don't know anything on dreamboxes. somewhere could be a setting to enable or disable web access from outside & perhaps a port setting where to access? webpage access is normally 192.168.1.1:80 or 192.168.1.1:8080 could be another port then change :80 to that port used on dm8000.
    Other issue could be your computer or router security settings (firewall, ...) not allowing traffic.

  5. #5
    V.I.P
    Join Date
    Dec 2004
    Location
    SW England
    Posts
    939
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Dm 8000

    Thanks M8
    Webinterface is enabled on the DM and I am following the instructions here and on the official site to the letter. I will check firewall then and see if windows 7 is being its usual crumby self but find it hard to think that the mac would play silly wotsits - it all looks so simple on the web pictures. Thanks - Brian

  6. #6
    V.I.P Giga's Avatar
    Join Date
    Feb 2009
    Posts
    4,161
    Thanks
    0
    Thanked 0 Times in 0 Posts
    if cccam running web interface and enabled and listening port not changed: Http://192.168.1.???:16001/
    check router for blocked traffic between computer/laptop and dreambox
    Last edited by Giga; 27-09-2010 at 11:18 AM.

  7. #7
    V.I.P
    Join Date
    Dec 2004
    Location
    SW England
    Posts
    939
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Dm 8000

    Hi Giga
    No - cccam not installed yet since I am stuck at this initial flashing point which is a bit like unlocking an Iphone - once done all is possible, but since it is even on the official DM website there is nothing sinister - just frustration that everyone else seems to have done it and I get blocked getting to the interface. Will switch off firewall and see if that helps - its only a backup lappie!!Nope - turning off Firewall doesnt help!! Brain
    Last edited by brain; 27-09-2010 at 12:32 PM.

  8. #8
    V.I.P
    Join Date
    Sep 2010
    Posts
    52
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Hi brain,
    As you have stated you have setup the webinfo via the plugin, the next step is to rerun your network wiz@rd and make sure you have a fixed IP.

    After you have rerun the wiz@rd carry out a hard reset of your box.

  9. #9
    V.I.P Giga's Avatar
    Join Date
    Feb 2009
    Posts
    4,161
    Thanks
    0
    Thanked 0 Times in 0 Posts
    check router! clear router logs. try access to dreambox. check router log for blocked traffic from computer to dreambox, if blocked traffic: make a rule allowing traffic between computer IP and dreambox IP
    Check router/modem if used RJ45 sockets are in the same segment! Sometimes these ports have IP addresses sitting in other IP address segment (ADSL2, VDSL modem/router with digital TV (STB television over ethernet)
    192.168.1.1-255
    192.168.2.1-255

  10. #10
    V.I.P
    Join Date
    Dec 2004
    Location
    SW England
    Posts
    939
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Dm 8000

    Thanks Giga
    Will try what you suggest but have checked router and access is open and allowed and access point registered on the DM. But I will have to close this thread since I have opened two on similar things. Many thanks - Brain. oops - how do I do that?

Similar Threads

  1. Dreambox 8000 and DVD install
    By airpilot in forum Dreambox DM8000
    Replies: 5
    Last Post: 16-10-2010, 09:30 PM
  2. Dreambox 8000 and Diablo Light 2.3 cam
    By minek10 in forum Dreambox DM8000
    Replies: 11
    Last Post: 04-05-2009, 11:14 AM
  3. Ez-box 8000
    By gasth404 in forum HD Satellite Receivers Discussion
    Replies: 1
    Last Post: 20-06-2007, 10:08 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •