Results 1 to 8 of 8

Thread: No signal since I have upgraded to 0.9.3661

  1. #1
    Junior Member
    Join Date
    Aug 2009
    Posts
    16
    Thanks
    0
    Thanked 0 Times in 0 Posts

    No signal since I have upgraded to 0.9.3661

    Since I have upgraded to version 0.9.3661 it happened 3 times already to loose the signal on all satellites.
    Even I reboot the box I still don't have signal on any TP or Satellites. The only workaround is to unplug the power cable and then it's working again.

    This has not happened before with the old 0.9.2371 that I was using it for more than 3 months.

    Does anyone know why this happens?

  2. #2
    V.I.P xanadu's Avatar
    Join Date
    Dec 2004
    Posts
    3,446
    Thanks
    129
    Thanked 207 Times in 126 Posts
    Probably you need to rescan all satellites and check your settings.

  3. #3
    Junior Member
    Join Date
    Aug 2009
    Posts
    16
    Thanks
    0
    Thanked 0 Times in 0 Posts
    I can't scan because there is no signal on the satellite .


    I have tried to restore to factory settings but this has not helped.

  4. #4
    V.I.P
    Join Date
    Feb 2009
    Posts
    495
    Thanks
    0
    Thanked 0 Times in 0 Posts
    then look for your Diseqsettings and set it right

  5. #5
    Junior Member
    Join Date
    Aug 2009
    Posts
    16
    Thanks
    0
    Thanked 0 Times in 0 Posts
    As I said if I unplung the power cable everything is back to normal when the box restarts.

    Now I have upgraded to the latest version. Lets see how it goes with this one.

  6. #6
    Junior Member
    Join Date
    Aug 2009
    Posts
    16
    Thanks
    0
    Thanked 0 Times in 0 Posts
    I have the same problem with 0.9.3686.

    I will go back to 0.9.2371 and see how it goes. I really hope that this is a software issue and not a hardware problem.

  7. #7
    V.I.P
    Join Date
    Sep 2008
    Posts
    579
    Thanks
    84
    Thanked 91 Times in 43 Posts
    Silly question but have set up your satellites again for your config IE: diseqc settings or motor settings?

  8. #8
    Junior Member
    Join Date
    Aug 2009
    Posts
    16
    Thanks
    0
    Thanked 0 Times in 0 Posts
    When I put a new firmware first I format application area.

    Obviously I have to re-configure the DISEq settings each time. This is not the problem.

    I don't have a reproducer but I suspects that this happens when I access TPs with low signal.

Similar Threads

  1. Can long cable lengths be used with HDMI
    By dave3dg in forum HD Chat
    Replies: 2
    Last Post: 18-10-2008, 09:22 PM
  2. Db 8000
    By brain in forum Dreambox DM8000
    Replies: 35
    Last Post: 29-10-2007, 05:35 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •