Hi!
I have a big problem with my Azbox with Firmware 3501 and Diseqc 1.1!
Here my config:
Toroidal T90 with 8 LNB's. EMP Centauri Multiswitch 17/8, Spaun SAR 411 Diseqc 4in1 and a Spaun SUR 420 as uncommited Switch.
1°W, 13°E, 19.2°E and 28.2°E are connected to the 17/8 switch.
5°E, 7°E, 16°E and 23.5°E are connected to the Spaun SAR 411.
To 2 of the 4 inputs of my Spaun SUR 420 (uncommited Switch) arrives a cable from 17/8 switch (output) and from SAR 411 (output). Then to output of my SUR 420 my Azbox is attached.
If I config the Azbox as Goran described in his do***entation, I get no signal on the 4 satellites attached on SAR 411!
I tried all other configs, but I get no signal on these for satellites!
On my dream all goes fine with this config:
LNB 0: 1°W, Switch A/A, uncommited Switch 1
LNB 1: 13°E, Switch A/B, uncommited Switch 1
LNB 2: 19.2°E, Switch B/A, uncommited Switch 1
LNB 3: 28.2°E, Switch B/B, uncommited Switch 1
LNB 4: 5°E, Switch A/A, uncommited Switch 2
LNB 5: 7°E, Switch A/B, uncommited Switch 2
LNB 6: 16°E, Switch B/A, uncommited Switch 2
LNB 7: 23.5°E, Switch B/B, uncommited Switch 2
Further the option "Sequence repeat" is switched on at Dreambox. No "Fast Diseqc" and no "Swap Commands"
What am I doing wrong? Is there a bug on firmware 3501? Not yet tried another firmware...
I also tried NOT to change "Committed/Uncommited" to "Uncommited/Commited" (as Goran said). But also no luck!!
Please help...
Thx in advance!
cu
KJ
Bookmarks