I'm getting that at 10db on my TBS card.
Getting the ITV Darts on 11088v at about 6db
And the Swansea v Cardiff feed at about 6.5db all same SR etc.
The german feeds always tend to be stronger for some reason.
Printable View
The Germans have always been an efficient race! :D
The Germans are back:
Attachment 68822
BUNDESLIGA
ID: 3L Magdeburg-Halle
MAGDEBURG vs HALLESCHER
ID: 3L Mannheim-Unterh.
MANNHEIM vs UNTERHACHING
ID: 3L 1860 Mchn-Koln
1860 MUNCHEN vs VIKTORIA KOLN
Not a sniff again below :20:
3W
11689 V 10000
ID: DEFAULT
4:2:0
Premier League / West Ham vs Newcastle
30 years since the wall came down (remember it vividly) the Germans are here again.
4 Bundesliga feeds booming in on 3W today. Here's one:
12643 V 20000
ID: 3L Ingolstadt
3LIGA
INGOLSTADT vs ZWICKAU
Attachment 68834
Attachment 68832
and...EPL Newcastle - Bournemouth
3w
11509 V 10000
id : UKI1646 NEP80 NUFC v BFC Main
....Still nought as now expected here in West Mids with 1.1m offset :eek:
All the FA cup matches have feeds reported on SU today. Most are in Biss, but some are shown as FTA.
There are a number a feeds reported on 3° west. I have tested these, and again no signal for me - 1.2m dish in SE UK.
Signal strength of the other feeds varies - one on 10° east I scanned in was only just receivable on the 1.2m dish.
Two more feeds today reported on SU (with the biss codes). Credit to slayer7 on SU for finding.
3 WEST 11666 V 10000 id=MOTD Watford-Everton
3 WEST 11471 v 10000 ID:=UKI-1493 NEP60 MOTD Newcastle
I can get the Watford-Everton feed, but with some hesitation. That is with my 1.2 metre CM dish just NW of London. Can't get anything on the other feed.
Also reported on SU is a 28°e feed for Crystal Palace vs. Sheffield United - everyone in UK should get that.
getting readings of 62 snr and47 agc and 67 and45 but dont have codes to decode ooops was on 3 east using dish 2 on chimney (sky dish motorized)
No joy with the EPL feeds at 3.0W as usual in West Mids with my 1.1m offset. Got the German matches at 3W earlier OK and UKI 1498 Enc 1 ITN Malvern Backup Truck at 3W attached pic.
Attachment 68953
28°E feed for Crystal Palace vs. Sheffield United - seems to be 422 today.
just reinstalled my dish. Got a little more signal but dont think it will be anywhere near enough for 3.0w feeds. Tuned the Odeon 24 transponder and currently @ 8.2db snr51% was 7.4 a few hours a go so looks like signal increases through the day.
Have you tried the ABS test card on 11461V 3062
That's a good tester.
I get ABS at 98% on my Triax 1.1 and TBS PC card.
I am in extreme SE UK.
I doubt that the 98% figure is correct though. Seems too high to me.
The picture is very stable though with no break-ups.
I am surprised I can get anything on this sat as I still yet have to tweak my dish.
Too busy doing jobs on wife's list. :(
I thought I would test this also as a diversion from something else I'm involved with at present.
I can get a video on the ABS test card, but it is breaking up - if it were a moving video, not sure how much would be viewable. For what it's worth the SNR is around 51%.
This is with a 120cm dish, northwest M25. Clear weather here today.
being that far south i would expect you to get more out of a 1.2
i need to check the dish is perfectly square to the motor. 3w is a good sat to hone alignment. a few turns of the mounting nuts can vary the signal by a db or 2. Busy painting. will get back to the dish at the weekend and see if anymore signal can be gained. either way it will be worth it for a boost on other sats if i can nail alignment.
I couldn't get any football feeds on this sat this season due to the storms battering my dish.
I still have not found the time to replace my 1.1 Triax with a new 1.25 Gibertini.
I have so many jobs to do around the house and the wife is always cracking the whip. :(
I thought taking early retirement was going to be a good idea. I am busier than ever now.
had another go today before the weather takes a turn for the worse. Ive tweaked the dish alignment to the motor pole clamp. On the Motor itself were you set latitude i used that surface to slide a ruler to the dish marking each side. It was the easy to notice the dish wasnt actually square on to the motor so i tweaked that but didnt really gain anything. There is play in the motor which doesnt help
This is what we get in Stoke on Trent 12462v 53%. Stable test card